Receiving J1939 Messages With The Pgn 61444; Table 16: Communication Settings For Pgn 61444; Table 17: Communications Settings In Pgn 61444 - Timeout And Conditions - Danfoss TFX Installation And Operation Manual

INFORMATION
The log le is sent to the Data platform when its size
reaches 1 kB, irrespective of the
period set.

5.2.3.1 Receiving J1939 messages with the PGN 61444

In the following, the example of a J1939 message is used
to explain the general procedure for con guring CAN
reception messages.
The procedure can also be applied to other CAN messages
from other CAN protocols.
For detailed information on creating objects, see chapter
Creating object dictionary groups and objects.
CREATING A PGN 61444
1. Create the object dictionary group
C > R
OMMUNI CATION E CEIVE
that your DOD le may already contain this.
2. In the object dictionary group
(PDOs), create a new object dictionary entry
M PD O.
ESSAGES
3. Rename the object R
E CEIVE
RECEIVE MESSAGE COMMUNICATION PARAMETERS
4. Right click on the PGN 61444 folder and select the
C tab.
OMMUNI CATION
C C
USTOM AN
C AN M (PDO ). Note
ESSAGES S
R C AN M
E CEIVE ESSAGES
R
E CEIVE
M PDO as 61444.
ESSAGE PGN
TFX INSTALLATION AND OPERATION MANUAL
5. Set and save the following:

Table 16: Communication settings for PGN 61444

Description Selection Function
Enabling the con guration, de ning the
V O C AN CAN interface for reception (if several
ALI D N
I Set are available).
NTERFA C E
The receive CAN message is a single
message (Layer 2). It is not treated according
CAN P None to a superordinate CAN protocol.
ROTO C OL
TIMEOUT AND CONDITIONSS
6. Select the T AN D C
IMEOUT
7. Set and save the following:
Table 17: Communications settings in PGN 61444 –
Timeout and conditions
Description Selection
A A Set
LWAYS C TIVE
6046279-001
March 2020
Operation
tab.
ON DITIONS
Function
The CAN message is received
irrespective of events or conditions.
23