Danfoss TFX Installation And Operation Manual page 48

Operation
The diagnosis le selected is loaded.
6. C Options > Communication Settings
LI CK ON
.
IN THE MENU
The window C
OMMUNI CATION
7. In the C G
OMMUNI CATION
D list and select the device
EVI CE
8. In the C
OMMUNI C ATION
G box.
ATEWAY
9. In the USB eld, go to the VIRTUAL COM-
and select the port you require (e.g. COM5).
10. Click on the O -C
NLINE HE CK
42
TFX INSTALLATION AND OPERATION MANUAL
S opens.
ETTINGS
eld, go to the G
ATEWAY
T S T
FX UPPORT OOL
G eld, check the
ATEWAY
P
ORT
button to check the connection.
If the connection is successful, the device information
of the TFXis shown in the ID
in the ID S
11. In the menu, click on CAN Filter Settings > Driver
optimized settings > Totally open for 11 and
29-bit messages.
12. Click on the OK button to save the settings.
13. Click on T
you can click on the button in the toolbar.
ATEWAY
.
The C
OMMUNI CATION
opens. The connected CAN devices with their
CANopen node-IDs, product codes, and information
list
on hardware and software versions are displayed.
14. Select the device you want to check.
15. Click on the C
The node-ID and the designation of the selected
device are shown in the toolbar.
16. Check the above-mentioned security variables and
device variables and make a note of their entries.
To view the current security and device variable entries,
select the variable you want and click on the Upload button.
For any further diagnosis, contact the support service.
See chapter Service and support.
6046279-001 March 2020
V
AN D
and HW SW V
TRING ERSION
> N S in the menu. Alternatively,
OOLS ODE CAN
- N S I
ODE CAN NFORMATION
button.
LOSE
NOTICE
INFORMATION
C area
ERSION ONTROL
elds.
window