Brennenstuhl HL 700 A - Rechargeable LED Hand Lamp Manual

SAFETY INFORMATION

• Carefully read these operating instructions before using the device.
• Do not use the light if it is damaged - danger of death. In this case, contact an electrician or refer to the specified service address.
• Do not look directly into the light.
• Never open the device.
• Do not use the working light in potentially explosive atmospheres - risk of death!
• To charge the batteries, only use a certified USB power supply unit.

COMMISSIONING

• Before using the device for the first time, completely discharge and recharge the rechargeable battery once.
• Switch at the back :
  Press 1x: LED on top on
  Press 2x: LED at front on
  if kept pressed once again, the light will be dimmed from bright to dark
  Press 3x: LEDs off or if kept pressed, the light will be dimmed from dark to bright
  Press 4x: LEDs off.
• Lamp can be used during charging.
• Charging display: if the lamp is switched on, the charging display is illuminated. The number of illuminated points indicates the charging status of the rechargeable battery.
• In cases of extended non-use, charge the rechargeable every 3 months.

CONTROL ELEMENTS

1. On/Off switch
2. Charging display (green)
3. Charging socket Micro-USB with cover cap
4. Front spotlight
5. LED lamp head
6. USB charging cable/Micro-USB
7. Swivelling hook
8. Magnet

CHARGING

Charge your battery using the supplied USB cable only. Exclusively use a certified USB power source (e.g. charging device, computer) with a maximum of 5 V output voltage: Connection: USB source – USB charging cable - charging socket.

Charging display : if the entire display is illuminated, the rechargeable battery is fully charged.

TECHNICAL DATA

Electronic appliances, batteries and rechargeable batteries must not be disposed of in household waste!

Old electronic and electric devices, as well as batteries and rechargeable batteries are special waste and need to be gathered separately and be sent for recycling in an environmentally friendly manner.

CONFORMITY DECLARATION

The Declaration of Conformity is filed with the manufacturer.

For further information, please refer to the Service/FAQ section on our homepage www.brennenstuhl.com.