Device Configuration - PROEMION FMM230 Device Manual

Table of Contents

Advertisement

5.3. Device Configuration

The device is already delivered with a pre-installed configuration. A customization of the logging
parameters is not possible in the field.
There are two modes for the device's data acquisition: On stop, Moving.
- The Moving mode is detected when the ignition signal is ON ¬ Data is recorded every 5 minutes and transferred
every 60 minutes
- The On stop (ignition signal has status low) data is recorded and transferred every 6 hours.
There is an Ignition On Counter which counts the time in seconds, when the ignition signal is ON. This value is
transferred with the default datasets and displayed as Estimated Machine Operating Hours.
Additionally a Towing Detection is implemented. This function detects a movement of the device (machine) while it
is in the "On stop" state. While the towing event is detected, the operation and recording mode changes to "Moving"
Table 8. Signals displayed at the DataPortal
Parameter
GPS latitude
GPS longitude
Ignition state
Estimated Operating Hours Total
Estimated Total Distance Travelled km Total mileage received.
Towing Detected
Supply Voltage Modem
Modem Disconnection From
Power Supply Detected
Internal Battery - State of charge
Internal Battery - Voltage
Cellular Signal Quality (1-5)
Basic Tracker Device Manual
Un
Description
it
°
Machine position.
°
Machine position.
The latest status of the terminal 15 (ignition key) is displayed. Ignition Off = 0
and Ignition Off = 1.
hr
Counter for the time in hours when the terminal 15 (ignition key) was at
status high.
Passive movement is displayed when there was a change of GNSS position
and terminal 30 or terminal 15 voltage at status low was detected.
V
The external supply voltage is displayed (terminal 30 voltage).
Indicatior for disconnected terminal 30 and terminal 15 voltage.
%
The latest level of charge of the internal battery relative to its capacity is
displayed.
V
The latest voltage of the internal battery is displayed.
Signal strengthe of GSM signal. Value in range 1-5.
1=bad
2=poor
3=fair
4=good
5=excellent

Advertisement

Table of Contents
loading

Table of Contents