Table of Contents
Advertisement
4.2. Connectors
The device is equipped with the following connectors:
• 1x main plug connector
4.2.1. Main plug connector
Use the main plug connector to connect the device to power supply and terminal 15 (ignition key) voltage. For the pin
assignment of the main plug connector, see the following overview.
Figure 4. Main plug connector
Table 3. Pin layout of main plug connector
Pi
Designati
Description
n
on
1
VCC
Power supply (10...30 V DC)
2
DOUT 3
Digital output, channel 3. Open collector output. Max. 0.5
A DC
3
AIN 2 /
Analog input, channel 2. Input range: 0...30 V DC /
DIN 3
Digital input, channel 3
4
DIN 2-
Digital input, channel 2, Negative input, Analog input,
N/AIN1
channel 1, Input range: 0...30 V DC
5
DIN 1
Digital input, channel 1
6
INPUT 6
TX EXT (LVCAN – TX)
7
GND
Ground
8
DOUT 1
Digital output, channel 1. Open collector output. Max. 0.5
A DC
9
DOUT 2
Digital output, channel 2. Open collector output. Max. 0.5
A DC
10 1WIRE
+3.8 V output for 1–Wire devices
POWER
11 1WIRE
Data for 1–Wire devices
DATA
12 INPUT 5
RX EXT (LVCAN - RX)
Basic Tracker Device Manual
Comment
Power supply
unused in Proemion application
unused in Proemion application
unused in Proemion application
used for the "working" signal (e.g.
TERMINAL 15 / IGNITION)
unused in Proemion application
Power supply
unused in Proemion application
unused in Proemion application
unused in Proemion application
unused in Proemion application
unused in Proemion application
Advertisement
Table of Contents
