Table of Contents
Advertisement
4.5. LED Indication
The device is equipped with two green LEDs to indicate the GNSS status and the operating status. See also
LED
Status.
Due to the fact that there is no additional light guide for the internal LEDs in the housing, the status
of the LEDs may not be recognizable in very bright ambient light. For a clearer visibility of the LEDs
please use a dark cloth or a similar tool to shade the area around the device.
5. Getting Started
This chapter describes the first steps that are required for the initial commissioning of the device. Furthermore, it
contains useful information on how to connect and mount the device.
5.1. Connecting the Device
1. Connect the device to the power supply. Refer to the pin layout of
2. If available, connect the machine's ignition signal. Refer to the pin layout of
3. Mount the device according to chapter
4. Protect the cable with sufficient strain relief and tubing.
WARNING
Overload damage due to malfunction.
Risk of severe or fatal injury.
- To limit the power in the event of malfunction, secure the DC power supply circuit during
installation with an external 3A fuse.
NOTICE
Risk of property damage.
- The device must be installed, connected, and commissioned by a qualified technician.
- Ensure the power supply is disconnected before connecting the device.
If you have any questions or anything is unclear, please contact our support before getting started. See
chapter
Service and
Basic Tracker Device Manual
Hardware installation
Support.
Main plug
connector.
Main plug
connector.
FMM230
Advertisement
Table of Contents
