Setup Menu Stick Welding (Smaw) - Yeswelder TIG-225P Operator's Manual

OPERATION
Work Clamp
Only plug a TIG Torch or Electrode Holder into the
right Socket.
Only plug the work clamp into the left Socket.
Select the STICK with process select button.
(See Figure 14)
Electrode Holder
FIGURE 14
Select the output current I
control button, turn the control knob to meet the
needs of the job. Higher amps for thicker material,
lower amps for thinner material.
Specify your Arc Force setting, the Arc Force
increases temporary the output current, used to
clear intermittent connections between the
electrode and the weld puddle that occur during
stick welding
To prevent serious injury and death: If the operator
is not holding the Electrode Holder, it must be
sitting on a nonconductive, nonflammable surface.
The Welder will immediately turn on when the Power
Switch is turned on.
14
1
with sequencer
(A)
FIGURE 15