Echo BEARCAT sc3206 Owner's Manual page 13

ENGINE THRoTTLE
Changes engine speed. Push lever to 1/2 throttle for
starting. Push lever to slow for idle and warm-up. Push
throttle lever to slow throttle to shut engine off. Refer to
engine manual for further engine operating instructions.
When chipping or shredding, the engine should be at full
throttle.
ENGINE cHoKE
use when starting a cold engine. Move lever to the choke
position when starting. Move lever to the run position
when engine is running (Figures 3.3 and 3.4). Refer to
engine manual for further engine operating instructions.
Figure 3.3 Briggs Throttle and Choke Locations
Figure 3.4 Honda Throttle and Choke Locations
KEY sWITcH
The key switch is used to start or stop the engine. See
Figures 3.5 thru 3.8 for keyswitch locations. Refer to the
engine manual for further operating instructions.
3 INCH CHIPPER/SHREDDER
FEATURES & CONTROLS
Figure 3.5 Honda On/Off switch
Figure 3.6 Honda Electric Key Switch
Figure 3.7 Briggs Electric On/Off Switch
Figure 3.8 Briggs Commercial On/Off Switch
9