Carbon Monoxide Monitor - Sea Ray Sundancer 350 Owner's Manual

s p
afeTY in
The bottle safety pin is used on boats equipped
with the Manual Fire Extinguishing System Pull
Handle. The safety pin, located at the neck of the
extinguisher bottle in the engine compartment, is
for shipping and transfer of the bottle only. The
bottle safety pin MUST be removed in order to
manually operate the system.
e r f
ngIne oom
( f . 44.1)
Ig
NOTE: THE MANUAL SYSTEM WILL NOT OPERATE
IF BOTTLE SAFETY PIN IS INSTALLED.
27. c
arbon
Your boat is equipped with carbon monoxide
(CO) monitors in the cabin and enclosed berths
or staterooms. The CO monitor is an electronic
instrument that detects carbon monoxide. When
there is a buildup of CO in the cabin, the monitor
will alert the occupants by flashing a DANGER light
and sounding an alarm. The CO monitor is powered
through a breaker on the Main Distribution Panel
in the salon.
It is important that you read and understand
the CO monitor information and operating
instructions. It is extremely important that
you become familiar with the CO monitor and
its functions.
T co M
esTing The
Test the monitor on your boat at manufacturers
required intervals by pushing the TEST button
on the side of the unit. If the unit is operating
correctly, both audible and visual warning
indicators will be activated.
44
DA_350_Book 1.indb 44
S 350 O
undancer
e
Ire xtInguISHer
REMOVE
SAFETY
PIN
M M
onoxiDe oniTor
oniTor
' M
wner S anual
c m m
arbon onoxIde onItor
(f . 44.2)
Ig
POWER
INDICATOR
HORN
! CAUTION
This detector will only indicate the presence of carbon
monoxide gas at the sensor. Carbon monoxide may
be present in other areas.
DANGER
!
Actuation of the CO monitor indicates the presence of
carbon monoxide which can be FATAL.
EVACUATE THE PREMISES IMMEDIATELY. DO A
HEAD COUNT TO CHECK THAT ALL PERSONS
ARE ACCOUNTED FOR. CALL THE NEAREST FIRE
DEPARTMENT AND ASK THEM TO DETERMINE THE
SOURCE OF CARBON MONOXIDE. DO NOT REENTER
PREMISES UNTIL IT HAS BEEN AIRED OUT AND THE
PROBLEM IS CORRECTED.
CAUTION
!
To reduce the risk of carbon monoxide poisoning,
test the monitor operation when not in use for 10
days or more.
e l
nD of ife signal
Your CO detector is equipped with an End Of Life
(EOL) signal indicating the sensor used in the unit
has reached the end of its service life and must
be replaced. The signal is activated from a timer
that will run for 4 years, 11 months from the date of
manufacture. Depending on your monitor, the EOL
signal indicator varies, so check the unit's operation
manual for further information and instructions.
The EOL signal can be reset for a period of 72
hours (3 days) for a total of up to 30 days. After this
time, the unit will continuously signal EOL and will
no longer detect CO and MUST BE REPLACED!
DANGER
INDICATOR
TEST
BUTTON
(ON SIDE)
Sundancer 350
6/20/2017 9:04:46 AM