Pioneer DVR-LX60 Service Manual page 54

1
No. Item
3
iPCR
A
4
GUID
VN
5
MN
TM
TS
CT
6
B
WP
PS
OS
CA
7
MD
[DVdecode:XXX]
8
LineSys
C
TC
9
RD
RT
ASPECT
CGMS
a
APSTB
D
DEC
SF
b
QU
AMODE
E
F
54
1
2
Description
iPCR value of the unit
GUID set in ConfigROM of the connected DV device
Vendor name set in ConfigROM of the connected
DV device
Model name set in ConfigROM of the connected
DV device
Transport Mode data obtained from the DV device
Transport State data obtained from the DV device
Cassette Type data obtained from the DV device
Write-protection data obtained from the DV device
Power-state data obtained from the DV device
Output signal mode data obtained from the DV
device
Connect AV data obtained from the DV device
DV device mode
Whether Yes (in the process of requesting DV
input) or No is indicated in XXX
Input Line System setting
Time-code data of the DVdecode Stream, or
response data of the Time Code command
Rec Date of DVdecode Stream
Rec Time of DVdecode Stream
Aspect Ratio of DVdecode Stream
CGMS of DVdecode Stream (from left to right,
CGMS data of bits 5-4: Audio ch 2, bits 3-2:
Audio ch 1, and bits 1-0: Video)
APS trigger bit of DVdecode stream
With/without DVdecode stream input
Sampling Frequency of DVdecode Stream
QUANTIZATION of DVdecode Stream
AUDIO MODE of DVdecode Stream
2
3
Data are displayed only if one DV device is identified.
If the connectd DV device is ROOT (IRM), IRM is displayed at
the side position of GUID display.
Data are displayed only if one DV device is identified.
(Depending on the device, the vendor name may not be set in
ConfigROM.)
Data are displayed only if one DV device is identified.
(Depending on the device, the model name may not be set in
ConfigROM.)
Data are displayed only if one DV device is identified.
Data are displayed only if one DV device is identified.
Camera or VTR is displayed only if one DV device is identified.
Normally, Yes is indicated only when CH is set to DV.
Stream time-code data are obtained when the tape is
played in forward direction. Otherwise, time-code data
are obtained through an AV/C command.
*CGMS (Copy Generation Management System): The
two-digit codes added to broadcast programs represent
the following:
00: Copy freely, 10: Once copy, 11: Never copy
With input: Signal type (525-60, 625-50, 1125-60,
1250-50, or Invalid) is indicated, Without input: "No" is
indicated.
If SF is 44 kHz, it is considered that 44.1-kHz audio is
input, and sound is muted on the unit.
DVR-LX60
3
4
Remarks
4