Sharp 4T-C70DK1X Service Manual page 11

LCD TV ADJUSTMENT ITEM
1. MICON SOFTWARE DATA INPUT
1) Main MICON/Monitor MICON Software Data Input (Main PWB : QPWBNH188WJ**)
ITEM CONDITION
1 Main MICON Checker
Data Input adjustment
(Main PWB) File version
confirmation
2. VCOM ADJUSTMENT
i) Enter service mode key and go to VCOM/TEST PATTERN Page
ii) Press "Enter" key (at VCOM)
iii) Adjust the flicker effect by pressing "CH up/down" of RC key
iv) Press "Enter" key after get the best value
3. SOFTWARE VERSION
Confirmation on Software version will be done during meeting.
Model
4T-C60DL1X
4T-C70DL1X
(Asia Destination)
4T-C60DL1X
4T-C70DL1X
(Philippines Destination)
4T-C60DL1X
4T-C70DL1X
(Hong Kong Destination)
Main Software Filename
4. WRITING CHANNEL PRE-SET
The step to use the pre-set channel is:
1. Extract the attachment/zip and get the folder "PresetChannel".
2. Copy this folder to top directory of USB Pen drive without rename the folder
3. Plug in to any USB port of TV
4. Enter K mode, pre-set channel will be loaded
5. End
Note: Inside New PresetChannel folder have three folders: Asia, Taiwan & Philippine.
Do choose correct destination model.
The folder is not compatible with version older than v0.89
5. WHITE BALANCE ADJUSTMENT/ GAMMA ADJUSTMENT
1. Data input by Gang Programmer
SOC IC :
RH-IXE260WJQZQ
Input Data: .bin file
(filename will be decided by Software Development Dept.)
2. At checker, confirm the version and perform operation
inspection.
Software Package
upgrade_Mango_vX.XXX_no_tvcertificate_releasekey.rar
upgrade_MangoP_vX.XXX_no_tvcertificate_releasekey.rar
upgrade_MangoH_vX.XXX_no_tvcertificate_releasekey.rar
: X.XXX is Software version
If any changes of software, will be informed by MARUHEN
5 – 4
PROCEDURE
4T-C70DK1X