Quick Software Transfer For Experienced Users; Fcc And Agency Compliance - Seagate Decathlon 850 Installation Manual

Ata interface drive

Hide thumbs Also See for Decathlon 850:

Table of Contents

Decathlon 850 Installation Guide, July 1995

drive, transfers the software to a diskette in Drive A. Instructions

for formatting the diskette and using the transfer program are on

page 17 and in the README.EXE file on the drive.

Quick software transfer for experienced users

1. Install the drive and turn the computer on.

2. Enter System Setup (your computer may call it CMOS or BIOS

setup). Select drive-type 2 for the new Seagate drive.

3. Boot the computer with a bootable, blank diskette for transfer-

ring the files.

4. Activate the prompt for the new Seagate drive.

5. Type seamove and press

software to the diskette in Drive A, erases the drive partition

and reboots the computer.

Your Seagate drive is intended to be contained solely within a

personal computer or similar enclosure (not attached to an exter-

nal device). As such, the drive is considered a subassembly and

no Federal Communications Commission authorization, verifica-

tion or certification of the device is required.

Seagate Technology, Inc. has tested these drives in an enclosure

as described above to ensure that the total assembly (enclosure,

disc drive, motherboard, power supply, etc.) does comply with the

limits for a Class B computing device, pursuant to Subpart J of

Part 15 of the FCC rules. Operation with noncertified assemblies

is likely to result in interference to radio and television reception.

. Seamove transfers the

ENTER

Table of Contents