Table of Contents
Advertisement
Command Control (Cont.)
P:K:<id>:<state>:[1:<addr>]:
<level>:<fade>
FBMODE=<mode>
FBMODE?
CONFIG?
RESET
VERSION?
ALD-D48 Network Lighting Solutions
Scene programming request.
This command is used to add or remove a light from a scene.
Program mode must be enabled for this command to work
(PROG=OPEN).
<id>: 1..100 = scene id to program
<state>: 0 = remove light from scene
1 = add light to scene
? = query for all lights in a scene
1: this value is always 1
<addr>: 1..48=address of light to add/remove
<level>: Level of light added to scene. Only valid when
state=1. Range is 0-100 percent.
<fade>: Fade time of light added to scene. Only valid when
state=1. Range is 0-14400 seconds.
P:K:1:?
P:K:6:1:1:26]:80:3
P:K:18:0:[1:12]
Set desired feedback mode. By default, the ALD-D48 will only
report feedback using channels. This command can be used to
alter this behavior.
<mode>: sum of the following desired feedback modes:
0 = no feedback
1 = channel feedback
2 = level feedback
4 = string feedback
FBMODE=7
// channel, level and
string feedback
FBMODE=3
// channel and level
feedback, no string
Query for the current feedback mode.
FBMODE?
ALD-D48 device server configuration request.
Get the current configuration information for an ALD-D48
device server.
CONFIG?
Reset request.
Forces an ALD-D48 device server to reset (reboot).
RESET
Version query.
Query for the current version number of the ALD-D48 device
server firmware.
VERSION?
Programming
21
Advertisement
Table of Contents
