AMX ALD-D48 Instruction Manual page 15

Configuring The ALD-D48 Device Server
*** AMX ALD-D48 Lighting Controller ***
Id number=3409669
Software version=02.4
Press ENTER to configure (timeout in 5 seconds)
FIG. 4 ALD-D48 Initialization
Once in the Configuration Menu (FIG. 5) you can display your current settings, set IP address, set
subnet mask, set IP address of a gateway, set the NetLinx device number for the ALD-D48, specify
NetLinx Master, exit without saving changes, or save changes and reboot.
*** AMX ALD-D48 Lighting Controller ***
***
1.
2.
3.
4.
5.
6.
X.
S.
Your selection:
FIG. 5 ALD-D48 Configuration Menu
Selecting Display current settings will give the settings currently configured for the device.
*** AMX ALD-D48 Lighting Controller ***
***
IP address:
Subnet Mask:
Gateway IP address:
NetLinx device number:
NetLinx Master:
Press any key to continue...
FIG. 6 Current Settings
Set IP address (FIG. 7) will provide you with the option to enable DHCP. If you select not to
enable DHCP you will be prompted to enter a new IP address.
Enable DHCP (y,n)? N
Enter new IP address: (010) .(000) .(000) .(005)
FIG. 7 Set IP address
Set subnet mask determines which IP packets will be processed based on the number of bits you
designate to be masked from the sender's IP address. FIG. 8 below has common examples and their
corresponding IP address.
Enter subnet mask as number of bits to mask.
Ex.
Ex. 12 bits = 255.255.240.0
Ex. 16 bits = 255.255.0.0
Ex. 24 bits = 255.0.0.0
Enter number of bits for masking (0..31)? 8
FIG. 8 Set subnet mask
8
Configuration Menu
Display current settings
Set IP address of this device
Set subnet mask of this device
Set IP address of gateway
Set NetLinx device number of this device
Specify NetLinx Master
Exit without saving changes
Save changes and exit (will cause reboot)
Current Settings
10.0.0.5
255.255.255.000
not defined
450
find master by IP address (192.168.224.42)
8 bits = 255.255.255.0
***
***
ALD-D48 Network Lighting Solutions