Wireless Security Setup - Motorola WE800G User Manual

SECTION 2
2-20
After you have logged in, for security reasons, you should change the User ID
and Password. See Wireless Security Setup.
4 Click the LOG IN button to enter the Wireless Ethernet Bridge's
Web-based Configuration Utility.

Wireless Security Setup

Follow these procedures to setup the correct security protocols for
your Wireless Ethernet Bridge.
1 Select Control Panel > Device Security.
2 In the Login User ID field, enter in the desired USER ID. For
strong security, select an ID that contains a multiple of
case-sensitive characters as well as numbers. It cannot be longer
than 64 bytes.
3 In the Login Password field, enter in the desired PASSWORD.
For strong security, select an ID that contains multiple of
case-sensitive characters as well as numbers and symbols like
"_ + )". It cannot be longer than 64 bytes.
4 In the Password Confirm field, re-enter the same PASSWORD.
5 Click APPLY.
6 Once the settings have been accepted, click RESTART and log
back into the Configuration Utility using your new User ID and
Password.
7 Select a Profile and navigate to the Basic tab.
8 Enter the Network ID (SSID) to match the SSID of the network
and click APPLY. Or, if using in Ad-Hoc mode, enter a user
friendly SSID, which will be used by your client adapter.
9 Navigate to Security.
10 Select Pre-Shared Key (PSK) from the drop down list of ESS
Auth Mode.
11 Select WEP128 from the drop down list of Encryption Status.
12 Click APPLY and click RESTART again. Your wireless
configuration is now complete for the selected Profile.
SECTION 2, INSTALLATION
INSTALLATION