Connecting The Printer; Commissioning; Connecting Power; Commissioning - Set-Up Mode - Novatech 1635 User Manual

2.16 CONNECTING THE PRINTER

A printer with a serial port, or a data logger, or a computer terminal may be connected to RS 232-C or the network port.
Data is logged out of the port as arranged in Set-up steps 58 and 59. The baud rate is selectable in set-up step 60. The
RS-232 protocol for the serial port is eight data bits, one stop bit, no parity.

2.17 CONNECTING POWER

Before commissioning the probe, sensor or analyser, read the two CAUTION paragraphs at the front of this manual.
Check that the mains supply voltage switch is set for the correct supply voltage.
2.18 COMMISSIONING – SET-UP MODE
Press the SET-UP button to select the 'SET-UP' mode. Most of the default settings of the functions will be correct, or
will have been pre-set at the factory. Refer to Section 4.5 for more details.
Check the following set-up functions -
1
2 to 6
7 to 10
11 & 12
13 & 14
15 & 20
24
29 & 30
49 to 54
551 to 57
2.19 COMMISSIONING – RUN MODE
When the analyser is turned on it will go to RUN mode. The SET-UP/RUN button will toggle between the two modes.
The upper line of the display will now read '% Water Vapour'. If the probe or sensor temperature is not above 650 °C,
a "Probe Low Temperature" message will be flashed on the lower line. The probe or sensor temperature can be
checked on the lower line of the display.
August 2009
1635 Water Vapour Analyser
Serial Port Connections

COMMISSIONING

Number of sensors
Date /time
Reference voltages
Probe/sensor offset(s)
Output channel mode (4-20, 0-20)
Output calibration
Dryer type
Sensor type(s)
Auto gas calibration checking
Alarm set-up
23