Midea MAW08V1QWT Installation Manual page 2

1. INSTALL THE SUPPORT BRACKET (cont.)
Use the provided 1/2" Type A screws.
1.3 Secure the bracket to the
NOTE: Drill 1/8" pilot holes before
screwing into the window sill.
2. SECURE THE UNIT ON THE BRACKET
2.1 Set the air conditioner on the support bracket and
fold down the side arm hinges.
WARNING
Do not leave the unit unattended during installation.
2.2 You must install the Open Window Brackets.
WARNING
Failing to do this could cause injury or property
damage.
Use the 1/4"
Type B
screw
Use the 1/2"
Type B screw
Installation Guide Page 4
3. SEAL AND CLOSE THE WINDOW
window with a screw at the end
of each extension arm as shown.
Holes at the end or bottom of
the Extension Arms can be used
to secure the Support Bracket to
the window.
3.2 Secure the anti-tip brackets into the window track and then close the window.
Top of Unit
Use the thick window sash
seal foam to seal between
Use the window sash seal foam to
the windows
seal between the windows
3.1 Measure, cut and install the side arm foam.
WARNING
Do not leave the unit unattended during installation.
Top view
Remove the factory installed 1/2"
screw and extend the Anti-Tip
Brackets into the window track.
Secure the Anti-Tip Brackets by
re-using the factory installed 1/2"
screw. Failing to use this screw
could damage the air conditioner.
Extend into Window Track
WARNING
You must extend the Anti-Tip Brackets into the Window
Track Opening. Failure to follow this warning may cause
serious injury.
3.3 Use the included foam to seal any gaps between the
window and the air conditioner.
Check
for
Gaps
Check fo
Page 5
3.4 Extend both window locks located in the window
slot. For additional security, install the window
sash lock.
FAQ
Why does the air conditioner not start?
- Wall plug disconnected. Push plug firmly into wall outlet.
- House fuse blown or circuit breaker tripped. Replace fuse with time delay type or
reset circuit breaker.
- Check if the light on the plug is on. If it is off, press the RESET button.
- Power is OFF. Turn power ON.
FAQ
Why is there noise during cooling?
- It is normal to hear airflow, set to a slower fan setting if too loud.
- Window vibration - poor installation. Refer to installation instructions or check with
installer.
FAQ
Unit will not connect to Wifi or App does not work?
For additional support and troubleshooting tips,
follow the link in this QR code.
Page 6 Installation Guide