Motorola HF850 Motomanual page 10

Installing the Power Cable and Fuse Kit
Caution: Failure to follow these steps may cause the
accessory not to work properly and may cause damage to the
car kit.
Speaker (SSN4020)
Microphone
(SMN4095B)
User
Interface
Module
(SYN1101A)
1 Remove all fuses and tape them to their respective
holders. DO NOT re-insert fuses until you complete and
inspect all connections.
2 Connect the fuse kit's GREEN Ignition Sense wire (3 amp
fuse) to an ignition-switched location on the fuse block.
When the ignition is off, the ignition sense line is low.
8
Wire Crimps:
green to green,
red to red,
black to black
Junction Box (SYN1102A)
Black:
Red: to a point in
to
fuse box that is
vehicle
always active
chassis
4 - 5 AMP fuse
Fuse Kit (SKN4937A)
Power Cable
(SKN4834A)
Vehicle
Radio
Orange
Blue
Yellow
Green:
to fuse
box