Wiring - Kicker PXA Mono Owner's Manual

Wiring

Click Here for Amplifier Install Kits
Model
PXA300.1
PXA600.1
Disconnect the vehicle's battery to avoid an
electrical short. A good ground connection
is important. If the PXA is mounted in the
front fairing of a motorcycle, it will be best
to extend the ground wire all the way to
the battery. Make the ground wire short,
24" (60cm) or less and, if not conneted
to the battery, connect it to a paint-and-
corrosion-free, solid metal area of the
vehicle's chassis. Adding an additional
ground wire of this same gauge (or larger)
between the battery's negative post and
the vehicle chassis is recommended. Keep
the audio signal cable away from factory
wiring harnesses and other power wiring. If
you need to cross this wiring, cross it at a
90 degree angle. Install a fuse at the blue
+12V constant wire. Fuse installation should
be as close as possible to the battery, and
no further than 18" (45cm) of the battery,
and in-line with the harness' power cable,
which is connected to your PXA Amplifier.
Make sure the power wire is routed so that
it will not be damaged, crimped, or shorted.
English
External Fuse (sold separately) Power/Ground Wire
1 x 40 Ampere
1 x 80 Ampere
8 Gauge
4 Gauge
KICKER Wiring Kit
KMPK8, PK8, CK8
KMPK4, PK4, CK4
6