Motorola V2288 User Manual page 86

         
The battery won't charge Check the alignment of the batteries to ensure that they are installed properly. Make sure that the positive
(+) and negative (-) marks on the batteries match the markings on the phone.
Check the charger. Is it properly connected? Is it fully inserted? Are its contacts clean and dry? The phone
should provide a beep-tone and the display should read "Charging Battery" within two minutes from the
transformer being installed. See 'Your Battery'.
Check the battery contacts. Are they clean and dry?
Check the battery temperature. If it is warm, let it cool before recharging.
Is it an old battery? Battery performance will decline after several years use. Replace the battery.
Are you using a Motorola original battery? See 'Your Battery'.
The battery drains faster than Are you in an area of variable coverage? This uses extra battery power.
normal
Is it a new battery? A new battery will need two to three charge/discharge cycles to attain normal
performance. See 'Charging a New Battery'
Is it an old battery? Battery performance will decline after several years use. Replace the battery.
Is it a battery that hasn't been completely discharged? Allow the battery to fully discharge (until the phone
turns itself off) and then charge the battery overnight.
Check that the Frequency Of Search feature in the Network Selection menu has not been set to Fast or
Continuous. See 'Network Search'.
Check that the Battery Saving Mode feature has not been set to Off.
Are you using your phone in extreme temperatures? At extreme hot or cold temperatures, battery
performance is significantly reduced.
You can't cancel Call Diverting or Wait until you are in an area with good network coverage and try again.
Call Barring
o
The symbol is flashing There is not enough memory available to store another SMS message. Use the Messages menu to delete one
or more existing messages.
You can't make international Some Service Providers automatically bar the ability to make international calls. Contact your Service Provider.
calls
Have you included the relevant codes? Press and hold the
+
( ) and then enter the appropriate country code followed by the phone number.
Your Personal Handsfree System Check all of the connections and make sure that they are inserted correctly.
is not operating properly
Check the connections to make sure that they are fully inserted.
English 84
What to do if...
key to display the international dialling prefix