Table of Contents
Advertisement
1-6
Back Panel Connectors
ID button with LED
1
When the system identification is active, the ID LED on the front/ back panel glows blue.
Serial Port
2
Connect to serial-based mouse or data processing devices.
3
VGA Port
Connect to a monitor device.
1GbE LAN Port #2
4
The Gigabit Ethernet LAN port provides Internet connection at up to 10 Gbps data rate. See the section
below for a description of the states of the LAN port LEDs.
USB 3.2 Gen1 Ports
5
The USB port supports the USB 3.2 specification. Use this port for USB devices such as a USB
keyboard/mouse, USB printer, USB flash drive etc.
1GbE LAN Port #1
6
The Gigabit Ethernet LAN port provides Internet connection at up to 10 Gbps data rate. See the section
below for a description of the states of the LAN port LEDs.
7
Server Management LAN Port
The LAN port provides Internet connection with data transfer speeds of 10/100/1000Mbps. This port is
the dedicated LAN port for Server Management.
LAN and ID Button LEDs
Speed LED
LAN Port
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
2
1
3
Link/Activity LED
10/100/1000 LAN LED:
ID button/LED:
Hardware Installation
4
6
5
5
State
Description
Yellow On
1Gbps data rate
Green On
100Mbps data rate
Off
10Mbps data rate
State
Description
Blue On System identification is active
Off
System identification is disabled
- 18 -
7
Advertisement
Table of Contents
