Weider Platinum 800 WESY75740 User Manual page 18

ATTACHING THE ACCESSORIES
To attach the Handle (96) to the high pulleys, first
attach the high pulley to the resistance system (see
ATTACHING THE HIGH PULLEYS on page 13). Then,
attach the Handle to a High Cable (101) with a Cable
Clip (94). Attach the other Handle to the other High
Cable in the same manner.
The Long Handles (not shown) and the Ankle Strap
(not shown) can be attached to the High Cables (101)
or the lower cable (not shown) with Cable Clips (94).
Attach the Hip Strap (not shown) to the ends of the
lower cable, or the optional lat bar to the Short Cables
(60), with two Cable Clips.
Note: A lat bar is an optional accessory for the
resistance system. To purchase a lat bar, call our
Customer Service Department toll-free at 1-877-992-
5999 and ask for model number WEMC0554.
ADJUSTING THE SEAT
The Seat (45) can be secured at various positions on
the Rail (4). To move the Seat, pull the Seat Knob
(48) out as far as it will go and slide the Seat to the
desired position. Engage the Seat Knob into an
adjustment hole in the Rail.
To perform row exercises, the hip strap must be
attached to the mech cable (see ATTACHING THE
ACCESSORIES above), and the Seat Carriage (44)
must be able to roll along the Rail (4). First, remove
the Backrest (35) from the Seat Carriage (see
ADJUSTING THE BACKREST on page 17). Then,
pull the Seat Knob (48) out as far as it will go, and
turn the Knob so that the pin rests at the end of the
"L"-shaped slot (see the inset drawing).
101
94
96
4
Adjustment
Hole
18
101
35
45
44
48
"L"-Slot
44
Pin
48