Main Function - Dialighting IW19-10 ZOOM User Manual

ENTER
5. DMX input:
DMX512 link, use 5-pin XLR cable to link the unit and DMX controller
6. DMX input:
DMX512 link, use 3-pin XLR cable to link the unit and DMX controller
7. DMX output:
DMX512 link, use 5-pin XLR cable to link the next unit
8. DMX output:
DMX512 link, use 3-pin XLR cable to link the next unit
9. Mains input:
Connects to power supply
10. Mains output:
Connects to next fixture
11. Fuse (T 6.3A):
Protects the unit from over-voltage or short circuit

3.2 Main Function

To select any of the given functions, press the MENU button until the required function is showing
on the display. Select the function by pressing the ENTER button and the display will blink. Use the
DOWN/UP buttons to change the mode. Once the required mode has been selected, press the
ENTER button to setup, to go back to the functions without any change press the MENU button
again. Press and hold the MENU button for about one second or wait for one minute to exit the
menu mode.
The main functions are shown overleaf:
To confirm the selected functions
5D