Dialighting IW19-10 ZOOM User Manual page 11

Temperature Unit
To Select Temperature Unit, press the ENTER button to show the TEMPERATURE UNIT on
the display. Use the UP/DOWN button to select ℃ or ℉, press the ENTER button to store. Press
the MENU button back to the last menu or let the unit idle one minute to exit menu mode.
Display Warning
To select Display Warning, press the ENTER button to show the DISPLAY WARNING on the
display. Use the UP/DOWN button to select No (Normal) or Yes (display will show the error
warning when the unit went wrong), press the ENTER button to store. Press the MENU button
back to the last menu or let the unit idle one minute to exit menu mode.
Fixture Test
Enter MENU mode, select Fixture Test, press the ENTER button to confirm, use the UP/DOWN
button to select Auto Test or Manual Test
Auto Test
To select Auto Test, press the ENTER button to show the AUTO TEST on the display. Press
the ENTER button, the unit will run built-in programs to automatically test pan, tilt and zoom.
Press the MENU button back to the last menu or exit menu mode after auto test.
Manual Test
To select Manual Test, press the ENTER button to show the MANUAL TEST on the display.
Press the ENTER button, and then use the UP/DOWN button to select channel, and adjust the
channel value. Once selected, press the ENTER button to setup, the fixture will run as the channel
value indicates. Press the MENU button back to the last menu or exit menu mode let the unit idle
one minute.
(All channels value will become 0 after exiting Manual Test menu)
Fixture Information
Enter MENU mode, select Fixture Information, press the ENTER button to confirm, use the
UP/DOWN button to select Fixture use time, Lamp On tme or Firmware Version.
Fixture use time
To select Fixture use time, press the ENTER button to show the FIXTURE USE TIME on the
10D