Hover-1 JOURNEY Operation Manual page 18

CHARGING YOUR JOURNEY
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power supply (100V 240V; 50 Hz/60 Hz).
• Align and connect the 1-pin charging cable into the charging port of the
Journey (DO NOT FORCE OR BEND THE CHARGING CABLE AS IT MAY
CAUSE THE PRONGS TO BEND OR BREAK).
• The charging indicator light on the charger itself should change to red,
indicating that your device is now being charged.
• When the red indicator light on your charger changes to green, then your
device is fully charged.
• After fully charging your Journey, unplug the charger from your device
and from the power outlet.
PREPARING YOUR E SCOOTER
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
ATTACHING THE HANDLEBAR ASSEMBLY
Attach the handlebar assembly by placing it into the steering column,
aligning the front and back bolt holes, and tightening the 4 bolts into place
with the hex key.
CAUTION
Only use the included charging
cable and charger to charge your
Journey. Using any other charger
may damage your Journey.
17