Default displays
Default display "Heating circuit" or "Continuous operation"
In the "Heating circuit" or "Continuous operation"
default display, you can adjust and check the most fre-
quently used settings:
Raises the room temperature value in weather-
compensated operation.
Raises the set flow temperature value in continu-
ous operation or room temperature-dependent
operation.
Lowers the room temperature value in weather-
compensated operation.
Lowers the set flow temperature value in continu-
ous operation or room temperature-dependent
operation.
Sets the "Heating" operating program for a heat-
ing circuit.
"DHW" default display
Fig. 8
In the "DHW" default display you can carry out the set-
tings and checks you use most frequently:
Raises the DHW temperature value.
Lowers the DHW temperature value.
"Energy cockpit" default display
When you call up the Energy cockpit for the first time,
a notification appears.
■
The Energy cockpit is opened once you confirm this
notification with
. The information is not shown
again when the energy cockpit is subsequently
called up.
■
If you tap on Cancel, the notification will appear
again the next time you call up the Energy cockpit.
22
To select "Standby mode".
Only for weather-compensated operation and con-
tinuous operation:
To switch the "Extended heating" function on or
off.
Only for weather-compensated operation and con-
tinuous operation:
To call up the "Time program heating" for central
heating.
The temperature display represents the selected set
room temperature (e.g. 20 °C) or set flow temperature
(e.g. 60 °C) for the current time phase.
Turns "DHW" "ON"
/"DHW" "OFF".
Calls up the "Time program, DHW".
To switch once-only DHW heating on or off.