PACH & COMPANY AeGIS AFGR9 Installation And Programming Manual page 20

Step 4 Press the screen will show
Admin Code
10
Step 5 Enter the new 4-digit ADMIN code then press
Step 6 Press to exit from the programming mode or continue programming.
NOTE: If you forgot the 4-digit ADMIN and MAGIC codes you must reset the system to factory default, see
steps below. Resetting the system will reset the all the parameters to factory default. The system will
keep the finger print template but all names associated with the templates will be deleted.
1. Turn off the system (Unplug the transformer).
2. Press and hold the
3. On display will appear firmware version.
4. Don't release the
5. On the display will appear message Initialize Flash.
6. Enter the Password 081745 then press
7. The parameters will be defaulted.
Pach and Company
AFGR9
_
, then plugin the transformer.
in about 5 seconds until the system beep three times.
Page 17
Chapter 3. Set Parameters
and then
07/28/04