Preventive Maintenance - Micromeritics SMART VACPREP Operator's Manual

6 Maintenance
P M
REVENTIVE AINTENANCE
Perform the following preventive maintenance procedures to keep the analyzer operating at peak
performance. Micromeritics also recommends that preventive maintenance procedures and
calibration be performed by a Micromeritics Service Representative every 12 months.
Maintenance Required
Instrument exterior
Port filters and
O-rings
Port gasket
Sample tube
O-ring
Vacuum pump
6 - 4
Frequency
Clean a needed or every 6 months.
Replace every 3 to 6 months.
Replace every 3 to 6 months (depending on the types of
analyses that were run).
Replace as required or every 3 to 6 months.
Reference the vacuum pump guide.
Smart VacPrep Operator Manual
067-42801-01 (Rev A) — June 2022