Advertisement
ASSEMBLY & INSTALLATION
Installing the Wine Cooler
This wine cooler is designed to be either built-in or
freestanding.
NOTE: This appliance may be used for the storage of
medicine and other medical products.
Place your wine cooler on a floor that is strong enough to
support it when it is fully loaded. To level the unit, adjust the
front leveling legs, or the screws on the wheels.
Make sure that the air vent at the front of the appliance is
never covered or blocked in any way.
NOTE: It is recommended that you do not install the
appliance near an oven, radiator or other heating source. Any
nearby heat sources may increase electrical consumption. Do
not install in a location where the temperature will fall below
50° F (~10°C) or above 110° F (~43°C). For best performance,
do not install the wine cooler behind a cabinet door or block
the vent in the front.
Avoid installing the wine cooler anywhere with excessive
moisture.
Plug the wine cooler into a properly grounded wall outlet. Do
not plug the wine cooler into a power strip or extension cord.
EXTENSION CORD
Because of potential safety hazards under certain conditions,
it is strongly recommended that you do not use an extension
cord with this appliance. However, if you must use an
extension cord, it is absolutely necessary that it be a UL/CUL-
Listed, 3-wire grounding type appliance extension cord having
a grounding type plug and outlet and that the electrical
rating of the cord be 110 volts.
INSTALLING THE STAINLESS STEEL
HANDLE
To install the handle, follow the instructions below:
1. Remove the rubber gasket from the right side of the inside
of the door (you don't need to remove the whole gasket,
just the side that covers the openings for the screws).
2. Remove the screws from the included bag. Feed the screws
through the holes from the inside until they poke through
to the outside front of the door frame.
3. Align the handle with the two screws, then tighten the
screws into the handle using a screwdriver until the handle
is both flush and secured tightly against the door frame.
DO NOT overtighten the screws, as you may cause
damage to the door frame.
4
Advertisement
