Download Print this page

Troubleshooting - NOVO NOVO15WINE1 Installation Instructions & Owner's Manual

15” wine cooler

Advertisement

TROUBLESHOOTING

Many common problems can be solved easily, saving you the time spent communicating with customer service.
Try the suggestions below to see if the issue has a simple solution.
PROBLEM
The wine cooler isn't working.
The wine cooler isn't cold enough.
The wine cooler turns itself on and
off frequently.
The interior lighting doesn't work.
The wine cooler is vibrating or
shaking a lot during operation.
The appliance seems to make too
much noise.
The wine cooler will not close
properly.
The wine cooler is beeping
consistently.
7
POSSIBLE CAUSE
It isn't connected to a power supply.
The wine cooler isn't turned on.
The circuit breaker is tripped, or a fuse has been
blown.
The temperature is not set correctly.
The ambient temperature could require a lower
temperature setting.
The door is being opened too often.
The door was not closed completely.
The door is not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked or too dusty.
The room temperature is higher than normal. A
large amount of food has been placed in the wine
cooler.
The door is being opened too often.
The door was not closed completely.
The door is not hermetically sealed.
It isn't connected to a power supply.
The light is turned off.
The circuit breaker is tripped, or a fuse has been
blown.
The appliance is not properly leveled.
The rattling may come from the flow of the
refrigerant, which is normal. As each cycle ends, you
may hear gurgling sounds caused by the flow of
refrigerant in your appliance. If the temperature
fluctuations occur, the contraction and expansion
of the inner walls may cause popping and cracking
noises.
The appliance is not properly level.
The appliance is not properly level.
The drawer was reversed and not properly installed.
The shelves are out of position
The door has been left open for more than 60
seconds.
The temperature has suddenly changed significantly
from the set temperature.
15" WINE COOLER USER MANUAL
REMEDY
Plug in the wine cooler.
Turn on the wine cooler.
Turn the circuit breaker back on,
or replace the fuse.
Check the set temperature.
Set to a lower temperature.
Do not open the door more often than
necessary.
Close door properly.
Check the door seal and clean or replace if it
does not provide a proper seal.
Clean the condenser when necessary.
Clear any obstructions and clean the dust.
Move the wine cooler to a cooler place.
Let the wine cooler run for a while to see if it
reaches the set temperature.
Do not open the door more often than
necessary.
Close door properly.
Check the door seal and clean or replace if it
does not provide a proper seal.
Plug in the wine cooler.
Turn on the lighting by pressing the lighting
button on the control panel.
Turn the circuit breaker back on, or replace
the fuse.
Level the wine cooler with the adjustable feet
or casters.
Level the appliance with the adjustable feet.
Level the wine cooler with the adjustable feet
or casters.
Level the appliance with the adjustable feet.
Check the drawer hinge and reassemble
correctly.
Check the shelves and refit correctly.
Close the door and leave it closed for at least
15 minutes.
Leave the door closed and wait for the unit to
reach the set temperature.

Advertisement

loading