Using The Vacuum; Professional - Shark NV85 Owner's Manual

Using the Vacuum

IMPORTANT: To protect your carpets, the
brushroll will only turn on when you have
pulled the handle back towards you and
released the Floor Power Nozzle.
3 Power Switch
Settings
OFF
Bare Floors / Tools
Carpets
Your Shark Navigator

Professional

®
Vacuum can be used to clean bare
floors or carpets – with the click of
a switch.
Stand the vacuum into the upright
position.
Plug in the vacuum.
1 Start with the Power Switch in the
"O" - Off position.
2 Place your foot on the Floor
Power Nozzle and pull handle
towards you.
3 Set the Power Switch to desired
cleaning setting.
4 Push the power cord into the
groove on the handle and then
secure the power cord into the
cord clip.
6 1-800-798-7398
NV85_IB_170427.indd 8
4
2
5 Press the On/Off switch to the"I"
position to vacuum bare floors or
cleaning with the hose (straight
suction only) or to the "II" position
to engage the motorized floor
brush (for vacuuming carpets
and rugs).
6 Due to the huge suction power
of this vacuum, it may become
necessary to adjust the suction
release on the hose. If the
vacuum is difficult to push or
pull or if it is lifting up area rugs,
adjust the suction release by
opening the valve at the top end
of the hose. Close the suction
release valve for maximum
suction when vacuuming floors.
Release suction for easier
push and pull on high pile
carpets and area rugs.
Suction Release
IMPORTANT: Your Brushroll
Indicator Light will illuminate solid
green when the brushroll is on,
or solid red if there is a blockage.
This feature is designed to protect
your Lifetime Belt that powers
your brushroll. See Checking for
Blockages on page 11.
NOTE: The height of your power
nozzle has been optimized for
easy pushing and superior
cleaning on all floor types, so
there is no need to make any
height adjustments as you
transition to different floor &
carpet types.
2017-04-27 11:34 AM
6