Table of Contents
Advertisement
Step #9 Car to car radio operation
Turn on car to car radio and select the channel you wish to transmit on. The incoming
volume of the other cars is controlled by the radio. If the incoming car to car audio is too
loud or too low simply adjust the volume control on the radio. Push the remote push to talk
on the steering wheel or headset when headset direct cables are used. The LED in the
intercom will turn from green to orange. This will show that the intercom is transmitting.
The car to car radio LED will turn red. This will show that the radio is transmitting.
The intercom LED will turn red when car to car radio is transmitting.
Note: Refer to radios owners manual for complete radio operation and functions.
Step #10 Car to car transmit level
The intercom is preset for the proper transmit level but fine tuning may be needed. If your
transmit volume to too low or your transmitting to much background noise simply adjust
the RADIO GAIN control on the back of the intercom. Remove the small round plastic
cover. Insert a small screw driver into the hole. Rotate the control one click at a time.
Counter clockwise will decrease the transmit level and clockwise will increase the transmit
level. Replace plastic cover when finished.
Step #11 Music input
The RRP600 has a 3.5mm plug in the front of the intercom and a rear molex cable for hard
wiring music devices (See Optional Accessories). For 3.5mm front port operation simply
plug in a 3.5mm stereo cable into the intercom and the music device. Turn on music device
and set the volume level. Since the RRP600 is a VOX intercom the music will mute when
talking over intercom or radio transmitting. If music is always muted reset VOX (Squelch)
control on the intercom so the mics turn off.
Note: The volume for the music is only controlled by the music device.
Step #12 Check installation
Check the entire installation. Make sure all cables are tied up and away from heat sources or
places where damage may occur. Check all bolts + mounting hardware to make sure
everything is tight. Once everything is checked you are ready to ride. Enjoy your off-road
4
adventure and be safe – communicate!
Advertisement
Table of Contents
Need help?
Do you have a question about the RRP660 and is the answer not in the manual?
Questions and answers