Table of Contents
Advertisement
Available languages
Available languages
pulling on the cord.
•
Keep the heater far from curtain or places where the air inlet can easily be blocked.
•
The power coupler is waterproof when not in sue. In order to prevent possible electric shock or
leakage current ,never use the appliance with wet hand or operate the appliance when there is water
on the power cord.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
6. OPERATING INSTRUCTIONS
1.
Position the fan heater so that it stands upright on a firm surface and at a safe distance from wet
environments and flammable objects.
2.
Connect the fan heater to the mains.
3.
Set the thermostat knob to the MAX and let the heater operate with full power.
4.
The fan heater will switch on when the heating selector is set to one of the power settings.
5.
Once the room reaches the required temperature, heating element will stop working, fan not
working. Once the temperature decreased, the heating element will be working. The fan heater now
starts and stops automatically and thus keeps the room temperature constant.
6.
Before switch off the heater, please turn the thermostat to MAX position and turn the switch to fan
position, let the appliance cool down for two minutes then turn off the heater and pull out the plug.
7. CLEANING AND MAINTENANCE
•
Before cleaning the appliance, disconnect it from the socket and let it cool down. The enclosure is
easily to get dirty, wipe it often with soft sponge. For every dirty parts, wipe with a sponge dipped
in <50°C water and mild detergent, then dry the heater enclosure with clean cloth. Be careful not
to let the water enter the appliance inner. Don't splash water onto the heater, never use solvent like
gasoline etc. to clean the heater, in order to protect the enclosure.
•
Clean the cord and plug, dry and pack it in a plastic bag.
•
When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in a
packing box and store it in a dry, ventilated place.
8. TROUBLE SHOOTING
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the service centre.
Problem
The heater does not
operate,even when it is
plugged in and the switch,
thermostat are switched on
www.eberg.eu
Possible cause
The plug is loose, bad
connection
No power in socket outlet
10
Treatment
Pull out the plug, check the
connection of the plug and
socket. Then connect again.
Insert the plug in a proper
socket
EBH
EN
Advertisement
Table of Contents
