Return To Factory Settings; Cleaning And Maintenance; Troubleshooting - Eberg ETW User Manual

EN ETW
POWER FAILURE MEMORY FUNCTION
In the event of a sudden power failure, the device retains the remembered operating mode and
automatically restarts it after reconnecting to the power supply.
However, the time settings must be re-done.

RETURN TO FACTORY SETTINGS

To reset the device settings, hold the on / off button for 10 seconds. Then press the button again.
The device will be restored to factory settings. The temperature in the comfort mode will be 19 ° C,
in the economy mode: 15.5 ° C. The hour will be [0000], the day of the week: [1], P1-P7 will be reset
to default settings.

CLEANING AND MAINTENANCE

DANGER! Danger of injury! Before carrying out any work on the device, always disconnect
it from the power supply.
ATTENTION! Danger of damaging the device! Do not use strong chemical cleaning agents
or solvents for cleaning. The plastic parts of the device may be damaged.

TROUBLESHOOTING

DANGER! Danger of injury! Incorrectly performed repairs may result in the equipment no
longer functioning safely. This poses a threat to the user and his environment.
Some minor disturbances can be removed directly by the user. To avoid additional costs
and problems, please check the solutions in the table below before calling qualified
service personnel.
PROBLEM
Device does not heat.
If the temperature of the device exceed max programmed temperature, or the temperature sensor
has a short circuit, the display shows an error [Er] instead of temperature.
POSSIBLE CAUSE
The device is switched off.
The set temperature is too
low.
There is no mains voltage.
31
SOLUTION
Switch the device on and set the
desired level of heat.
Set the higher temperature.
Check the power cord, plug, socket
and fuse.
www.eberg.eu