Advertisement
3.
Select a Signal type. You can use all the speech signals designed for
target matching in the Verifit
4.
Select a RECD source:
•
To use Verifit measured, be sure to make the RECD measurement
on the Verifit before opening REM AutoFit with VerifitLINK. To use a
previously measured RECD, enter data in the Genie 2 RECD tool and
select Genie 2.
To use Genie 2, be sure to select the desired measurement in the
•
RECD tool before opening REM AutoFit with VerifitLINK. You can
import a measured RECD into the RECD tool from NOAH.
5.
Prepare for the measurements by following the instructions to the
right of the screen. These instructions are specific to the measurement
method you have selected.
•
One of the instruction points contains a link to open ProbeGUIDE on
the Verifit2.
•
When this link is opened a small popup appears in Genie 2 where it is
possible to start the ProbeGUIDE measurement for each ear. A graphic is
shown on the Verifit2 screen showing an ear and ear canal. As you insert
the probe tube, on the ear canal graphic an indicator ball will show the
position of the end of the probe tube. The marker and chime will show
that the placement is correct.
It is now possible to proceed with the measurement.
4
Advertisement
