Advertisement
Quick Links
Advertisement
Related Manuals for oticon REM AutoFit
Summary of Contents for oticon REM AutoFit
- Page 1 AutoFit with Verifit LINK ® Quick Guide...
- Page 2 Quick, accurate and automatic verification with your Verifit. What is REM AutoFit? REM AutoFit is a tool in Genie 2 that allows the Real ear measurements must therefore be the Measurement module tab. Go to REM AutoFit HCP to match real ear targets automatically. This consistent, reliable, repeatable, and correct.
- Page 3 On the Fitting step in Genie 2, enter the REM tool from the More Tools menu is open and restored to their original states afterwards: in the left taskpane. Launch REM AutoFit with VerifitLINK by clicking the VerifitLINK button at the bottom of the REM tool.
- Page 4 Select a RECD source: • To use Verifit measured, be sure to make the RECD measurement on the Verifit before opening REM AutoFit with VerifitLINK. To use a previously measured RECD, enter data in the Genie 2 RECD tool and select Genie 2.
- Page 5 In the Measure step, there are two ways of performing verification Step 2: Measure measurements: Automatic and Manual. Note that for simultaneous binaural measurements, Audioscan recommends that the client is a distance of 45–60 cm (18–24 in.) from the loudspeaker. Automatic: measures the current instrument output, automatically adjusts All measurements use the signal type selected in step 1: Setup.
- Page 6 This manual process can be done after or instead of the automatic process. Within the REM AutoFit tool, use the fine-tuning controls to adjust the gain and then manually run a measurement to verify the target match.
- Page 7 Select Discard all changes to discard adjustments. The data in use when you entered REM AutoFit with VerifitLINK will be restored. If you no longer want to use the adjustments made in REM AutoFit with VerifitLINK, go to the Hearing Instrument top menu and click Represcribe settings.
- Page 8 oticon.com...