Table of Contents
Advertisement
MITSUBISHI BRAND DIRECTV PLUS™ DIGITAL SATELLITE RECEIVER
DUAL – Refers to the larger, oval, multi-LNB satellite dish. This dish will be configured with two
LNBs in the positions marked "SAT A" (101 ) and "SAT B" (119 ). Each LNB will have two outputs.
(SR-SD200)
TRIPLE - Refers to the larger, oval, multi-LNB satellite dish. This dish will be configured with three
LNBs in the positions marked "SAT A" (101 ), "SAT B" (119 ) and "SAT C" (110 ). Each LNB will
have one or two outputs. (SR-SD200 used with additional LNB for SAT C. The additional LNB is
available from your installer.)
Note: Choosing the correct dish type is necessary to obtain correct pointing results.
Position
After selecting Position from the INSTALLATION screen a pop-up menu called Alignment Mode
will appear. You can enter your location by either Align by ZIP or Align by LAT/LONG. After making
your selection, the appropriate pop-up entry panel will appear. Use the
and
keys or use the
numeric keypad to change the value of the digits. Press the key to advance or the
key to back up.
Once you have entered all of the correct digits, select OK. The calculated results on the proper
direction to point your satellite dish antenna will be displayed.
Things to do in the INSTALLATION screen
Here, the quality of the satellite signal is automatically displayed. In addition to using this at
installation time, you can use it to troubleshoot if you experience loss of signal, momentary video
freezing, or similar problems.
System Test
Whenever you experience a problem with your satellite system, you can use the SYSTEM TEST
screen, which runs a series of internal diagnostics that will provide
you with basic information about the status of your system.
Things to do in the SYSTEM TEST
screen
Receiver Test
Depending on your test results, you may be able to remedy the
problem yourself. For example, if your Access Card is missing,
verify that it is facing the right direction and try reinserting it. A "No
Dial Tone" message indicates that the phone line is in use or the
SYSTEM TEST screen
digital satellite receiver is disconnected from the phone line. If you
cannot remedy a problem yourself, call your dealer or Mitsubishi Consumer Relations at 1-800-332-
2119 and provide the technician with a complete description of the problem and the results of the
system test. The technician will assist you with additional repair information and instructions.
Cable Test
When Cable Test is selected the digital satellite receiver scans through all transponders and displays
the signal strength for each. If there are any detectable problems, you will be notified of the most likely
cause of the problem. Otherwise, you may simply find this test to be a convenient way to analyze your
signal quality.
P
7-14
AGE
Advertisement
Table of Contents
