Attaching The Satellite Disha; To The Mast Or Pole - Mitsubishi SR-SDI Owner's Manual

2) Install the mounting bracket
of the LNB support arm onto
the four flat-head screws, as
shown.
3) Loosely install a ¼-inch nut
onto the portion of each flat-
head screw that sticks
through the back of the
reflector and mounting
bracket.
4) Tighten the four ¼-inch nuts.
The heads of the flat-head
screws must be flush on the
inside surface of the reflector
to be securely fastened to the
LNB support arm.
5) Install the cable clip as
shown.
Attaching the Satellite Dish
Antenna Assembly to the Mast
or Pole
Now that you have assembled the satellite dish antenna you are ready to mount it on your
INSTALLING THE SATELLITE DISH ANTENNA
previously installed mast or pole. While the diagrams may
show a satellite dish antenna model that differs from the one
you have, the same procedures apply.
1) If necessary, slightly loosen the azimuth nuts on the
LNB support arm.
2) Slide the satellite dish antenna assembly onto the mast
or pole until the top of the mast stops at the bolt at the top of
the mounting assembly.
3) Tighten the azimuth nuts enough so that the satellite
dish antenna assembly can rotate easily on the mast or pole.
4) The next step is to ground the satellite dish antenna.
P 4-13
AGE