Table of Contents
Advertisement
MITSUBISHI BRAND DIRECTV PLUS™ DIGITAL SATELLITE RECEIVER
For the traditional 18" satellite dish, confirm that you have all of the components listed below.
Steel reflector (1)
Mast (1)
Base plate (1)
LNB support arm (1)
For the larger, oval, multi-LNB satellite dish, refer to the additional assembly
documentation included with the satellite dish.
If you are missing any parts contact Mitsubishi Consumer Relations at 1-800-332-2119.
Your satellite dish antenna will need to be pointed at a satellite cluster located 22,300 miles in
orbit above the equator. To aim the satellite dish antenna at the satellites you need to know the
azimuth and elevation angles. The digital satellite receiver will assist you in determining these
angles. If you see the message:
"Searching for satellite signal. To access related utilities, press
press the
key. Otherwise, press keys in the following order to navigate to the
INSTALLATION screen:
or
to move the highlight over the Setup Menu button
to display the SETUP MENU
or
to move the highlight over the Installation button
to display the INSTALLATION screen
Determine Where to Point Your
Satellite Dish Antenna
The INSTALLATION screen
When you press
you will see a screen that assists you with the satellite dish antenna
pointing and signal strength utilities.
Move the highlight to the Dish Type button and press
will need to specify the style of dish you have so that the pointing
information will be accurate. Press the
control or receiver front panel until your preferred selection is
highlighted.
SINGLE – Refers to the traditional 18" satellite dish. This dish will
be configured with an LNB with either one or two outputs.
(SR-SD100)
DUAL – Refers to the larger, oval, multi-LNB satellite dish. This
dish will be configured with two LNBs in the positions marked
"SAT A" (101 ) and "SAT B" (119 ). Each LNB will have two
outputs. (SR-SD200)
TRIPLE - Refers to the larger, oval, multi-LNB satellite dish. This dish will be configured with
three LNBs in the positions marked "SAT A" (101 ), "SAT B" (119 ) and "SAT C" (110 ). Each
LNB will have one or two outputs. (SR-SD200 used with additional LNB for SAT C. The
additional LNB is available from your installer.)
P
4-2
AGE
Dual output LNB (1)
¼-inch nuts (5)
Retainer screw (2)
Flat head screws (4)
to display the MAIN MENU
or
keys on the remote
¼-20 x ½-inch
grounding bolt (1)
."
. You
The INSTALLATION screen
Advertisement
Table of Contents
