Mitsubishi Electric WD-57733 Owner's Manual page 8

C, y, 733, 734 series dlp high-definition television
Hide thumbs Also See for WD-57733:
Table of Contents

Advertisement

8
1. Television Overview
Front-Panel Indicators
Off
Steady On
LAMP Indicator
LED Color TV Condition
Normal TV on or standby condition.
None
TV just powered off and lamp is
Green
cooling.
1. Lamp access door is open or
Yellow
not secure.
2. No lamp installed.
Lamp no longer illuminates and has
Red
reached the end of the lamp life.
STATUS Indicator
LED Color TV Condition
Normal TV on or standby condition.
None
TV is too hot.
Yellow
TV may require service.
Red
TIMER Indicator
LED Color TV Condition
TV is powered off.
None
TV is powered on.
Green
TV powered off, auto-on timer is set. Normal operation. TV can be turned on at any time.
Green
1. TV just plugged into AC outlet.
Green
2. AC just restored after power failure.
3. TV rebooting after System Reset
used.
4. TV rebooting after power fluc-
tuation or receiving abnormal
digital signals from a digital
channel or digital device.
5. You have begun the procedure
to update software from an
authorized flash memory device.
Slow Blinking
Fast Blinking
Additional Information
Normal operation.
Starts to blink 30 seconds after turning off TV. TV can be turned
on before blinking starts or after blinking stops, but not while the
indicator is blinking. Normal operation.
TV will not operate until lamp access door is secure. See
Appendix C for installation information.
TV will not operate without a lamp. See Appendix C for installa-
tion information.
Replace the lamp. The TV will not operate when the lamp no
longer illuminates. See Appendix C for installation information.
Additional Information
Normal operation.
The TV will display a warning message and shut off if it overheats.
Ambient room temperature may be too high. Turn off the TV
and wait until the room temperature drops.
Clear blocked air vents. Ensure at least a four-inch clear-
ance on all sides of the TV.
Clean the lamp-cartridge air filter. See Appendix C.
Turn off the TV and unplug the set from the AC power source.
Wait one minute and then plug the set back in. See Appendix E.
If the LED is still on, contact your dealer or a Mitsubishi
Authorized Service Center. Go to www.mitsubishi-tv.com or call
1-800-332-2119 to receive Authorized Service Center information.
Additional Information
Normal operation.
Normal operation.
Wait approximately one minute for blinking to stop before
turning on. Normal operation.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd-57734Wd-65733Wd-65734Wd-73733Wd-73734Wd-c657 ... Show all

Table of Contents