Table of Contents
Advertisement
16
2. TV Setup
Initial TV Setup
M emorizing Channels
For Reception on ANT 1 and ANT 2
To start channel memorization
1.
Connect the incoming cable to
This is the cable from an antenna or a cable service
without a cable box.
2.
Press
MENU to open the Main menu.
3.
Press
to highlight the Setup icon and display the
Setup menu.
4.
With the
Setup menu displayed, press
light the Scan icon.
Start channel memorization from the Setup menu.
5.
Press
to highlight an input selection based on
your connections:
Input
Condition
Ant 1 Air
When connected to an indoor or
Ant 2 Air
outdoor antenna
Ant 1 Cable
When connected to direct cable (no
Ant 2 Cable
cable box)
6.
Press
to highlight the on-screen START button.
7.
Press
ENTER to start automatic channel memoriza-
tion.
To stop channel memorization before
completion, press CANCEL.
8.
When memorization is complete you can:
•
Press MENU once to return to the top row of icons.
•
Press MENU again to return to the Main menu.
•
Press EXIT to watch TV.
After channels have been memorized:
•
To tune to memorized channels, press CH
while watching TV on the ANT 1 or ANT 2 input.
•
Use the Setup > Edit menu ( page 47 ) for additional
channel options, such as adding or deleting chan-
nels from memory, naming channels, and saving
favorite channels in custom memory banks.
ANT 1 or ANT 2.
to high-
/
More Setup Options
See chapter 5, "TV Menu Settings," to:
•
Set the TV clock ( page 48 )
•
Set the TV Timer ( page 49 ) to have the TV power on
at a preset time.
•
Select an Energy Mode to manage power use while
the TV is off ( page 50 ).
•
Enable 3D video ( page 38 ).
Setting Up TV Inputs
When You First Connect a Device
The TV's Easy Connect™ Auto Input Sensing feature
detects most connections automatically.
Note: For connection and setup of a personal com-
puter, see the information on page 20 .
Auto In put Sensing for Most Devices
When you first connect a device, the TV will:
a. Detect the connection and automatically switch
to the input
b. Prompt you to identify the device type (if not
recognized automatically)
c. Prompt you to perform Net Command IR setup
for the device, if available
d. Repeat these steps for any additional newly
detected devices
See below for connections which trigger Auto Sensing.
Auto Input Sensing Available
Y/VIDEO (detected as composite video)
Y/VIDEO plus Pb (detected as component video)
S-VIDEO
*
HDMI
USB (USB photo port)
INPUT 4 AUDIO (for an audio-only device; see page 27 .)
Auto Output Sensing Available
DIGITAL AUDIO OUTPUT (orange jack)
AVR AUDIO OUTPUT (red jack)
No Auto Sensing
ANT 1 and ANT 2
If the HDMI device is powered off when connected,
*
detection occurs when the device is next powered on.
Auto Input Sensing for CEC-Enabled Devices
When the TV's NetCommand for HDMI feature is enabled,
most CEC-enabled devices are recognized and identified
automatically by the TV. Net Command for HDMI may
allow you to control functions of a CEC-enabled device.
See Appendix D , "NetCommand HDMI Control of CEC
Devices," page 78 .
Advertisement
Table of Contents
