Advertisement
Quick Links
Quick Start EVK-M10QSAM / M8QSAM / M8xCAM
1. Overview
A (USB)
C (RS232)
D (RST)
G (Boot)
F (14-pin connector)
UBX-16024579 - R04
E (RF IN)
EVK-M8xCAM only
B (USB/RS232 switch)
2. Setup
1.
Download and install the EVK-M10QSAM / EVK-M8QSAM
/ EVKM8xCAM software (and documentation) from
www.u-blox.com/evk-search.
See installation notes on the back of this card.
2.
Connect the unit to a PC. Options:
• USB: Connect via USB port (A). Set switch (B) to
USB. The USB driver installs automatically when
the device is connected to a PC; this requires an
internet connection.
• UART: Connect via RS232 (C). Set switch (B) to
RS232.
NOTE: Press RST (D) after setting switch (B).
3.
Provide power to the device at all times, either via USB on
the back or the V5 IN pin on the front (F).
4.
EVK-M10QSAM / EVK-M8QSAM: Place the EVK with
an unobstructed view of the sky, no external antenna
connectivity at (E).
5.
EVK-M8QCAM / EVK-M8CCAM: Place the EVK with an
unobstructed view of the sky or connect antenna signal
to (E).
6.
Start the u-center GNSS evaluation software and select
the corresponding COM port and baud rate.
Copyright © 2022, u-blox AG
Advertisement
Related Manuals for u-blox EVK-M8 CAM Series
Summary of Contents for u-blox EVK-M8 CAM Series
- Page 1 EVK-M8QCAM / EVK-M8CCAM: Place the EVK with an unobstructed view of the sky or connect antenna signal F (14-pin connector) to (E). Start the u-center GNSS evaluation software and select the corresponding COM port and baud rate. UBX-16024579 - R04 Copyright © 2022, u-blox AG...
- Page 2 • Supported Windows operating systems: Windows 7 The u-center GNSS evaluation software provides a powerful onwards (x86 and x64 versions) tool for evaluation, performance analysis and configuration of u-blox positioning products. • For EVK-M8QSAM, EVK-M8QCAM, or EVK-M8CCAM download the u-center evaluation software 7. More information •...