Table of Contents
Advertisement
en Cleaning and servicing
Before the next wash
To prevent unused detergent from
flowing straight into the outlet in the
next wash, run the
after you have emptied the drain
pump.
Turn on the tap.
1.
Insert the mains plug.
2.
Switch on the appliance.
3.
Pour 1 litre of water into the
4.
manual dosing compartment.
Start the
programme.
5.
Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
48
programme
Clean the water outlet hose and si-
4.
phon connecting piece.
Reattach the water outlet hose and
5.
secure the connection point using
the hose clamp.
Clean the water inlet filters.
Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
Turn off the tap.
1.
Set the Algodón/Algodão
2.
gramme.
Start the programme and leave it
3.
to run for approx. 70 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
pro-
Advertisement
Table of Contents
