Pnp/Pci Configuration Option - ECS L4S5MG/GL Manual

IRQ [3-7, 9-15], NMI (Enabled)
This option determines whether any activity for IRQ 3-7/9-15 will cause the
system to wake from a power saving mode.
IRQ 8 Break Suspend
Determines whether the system will monitor IRQ 8 activity and wake the sys-
tem from a power saving mode when IRQ 8 is activated.
Ring/WOL/WOM PowerUp Contl (Disabled)
Use this item to enable LAN or modem activity to wakeup the system from a
power saving mode.
PCIPME Power Up Control (Enabled)
Use this item to enable PCI activity to wakeup the system from a power sav-
ing mode.
Power Up by Alarm (Disabled)
When set to Enabled, the following three fields become available: Month
Alarm, Day of Month Alarm, and Time Alarm Upon arrival of the alarm time, it
will instruct the system to wake up. When set to 0 (zero) for the day of the
month, the alarm will power on your system every day at the specified time.

PNP/PCI Configuration Option

These options configure how PnP (Plug and Play) and PCI expansion cards oper-
ate in your system . Both the ISA and PCI buses on the Mainboard use system
IRQs (Interrupt ReQuests) and DMAs (Direct Memory Access). You must set up
the IRQ and DMA assignments correctly through the PnP/PCI Configurations
Setup utility for the mainboard to work properly. Selecting PnP/PCI Configurations
on the main program screen displays this menu:
CMOS Setup Utility – Copyright (C) 1984 – 2001 Award Software
Reset Configuration Data
Resources Controlled by
x IRQ Resources
PCI/VGA Palette Snoop
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
INT Pin 5 Assignment
INT Pin 6 Assignment
INT Pin 7 Assignment
INT Pin 8 Assignment
↑ ↓ → ← : Move Enter : Select
F5:Previous Values
Reset Configuration Data (Disabled)
If you enable this item and restart the system, any Plug and Play configuration
data stored in the BIOS Setup is cleared from memory.
PnP/PCI Configurations
[Disabled ]
[Auto(ESCD)]
Press Enter
[Disabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults
40
Item Help
Menu Level
Default is Disabled.
Select Enabled to reset
Extended System Con-
figuration Data (ESCD)
when you exit Setup if you
have installed a new add-
on and the system recon-
figuration has caused
such a serious conflict
that the OS cannot boot
F1:General Help
F7:Optimized Defaults