Philips 55PFL6900/F7 Service Manual page 37

Note:
(1) Order of steps in procedure. When reassembling,
follow the steps in reverse order. These numbers
are also used as the Identification (location) No. of
parts in figures.
(2) Parts to be removed or installed.
(3) Fig. No. showing procedure of part location
(4) Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P = Spring, L = Locking Tab, S = Screw,
H = Hex Screw, CN = Connector
e.g. 2(S-2) = two Screws of (S-2),
2(L-2) = two Locking Tabs of (L-2)
(5) Refer to the following "Reference Notes in the
Table."
Important precautions concerning the
LCD Panel Assembly:
1. When you disassemble/re-assemble the LCD
Panel Assembly.
• Do not pull the FFC Cable and Board Cable
forcefully when you re-assemble.
• Be careful not to scratch the display panel when
assembling.
• Make sure to replace the Decoration Plate, LED
Lens and Leading Edge Cover to a new one when
replacing the LCD Panel Assembly.
• Make sure the T-CON Module and T-CON Holder
are securely in place when assembling.
2. When you disassemble/re-assemble the
Function CBA Unit or the IR Sensor CBA Unit.
• Be careful not to break the hooks. If you pull with too
much force, the hooks may be damaged.
• Make sure the hooks are securely in place when
assembling.
• The Function CBA Unit, Function Knob and Knob
Frame are fixed in place by the hooks. Make sure
these hooks are not damaged. Make sure the
Function CBA Unit, Function Knob and Knob Frame
are securely in place when re-assembling.
• The IR Sensor CBA Unit and Sensor Shield are
fixed in place by the hooks. Make sure these hooks
are not damaged. Make sure the IR Sensor CBA
Unit and Sensor Shield are securely in place when
re-assembling.
3. When you disassemble/re-assemble the Front
*4
Cabinet.
• Be careful not to break the hook. If you pull with too
much force, the hooks may be damaged.
• Make sure to replace the Cell Cushion and Duble
Side Tape to a new one when replacing the Front
Cabinet.
*4 : 55PFL4901/F7
4-20 PL15.16-C_DC