NEC PV800UL-W User Manual page 37

Terminal Panel Features
3
1. HDMI 1 IN Terminal (Type A)
Connects to the output terminals of a com-
puter, blu-ray player, etc.
2. HDMI 2 IN Terminal (Type A)
Connects to the output terminals of a com-
puter, blu-ray player, etc.
3. Ethernet/HDBaseT Port (RJ-45)
Connects to a commercially available HD-
BaseT compatible transmission devices.
4. AUDIO OUT Mini Jack (Stereo Mini)
Outputs the audio signal corresponding to
the image projected from the projector.
5. USB Port (Type A)
Use a 5 V / 1.4 A power supply.
6. LAN Port (RJ-45)
Connects the unit to a wired LAN.
7. PC CONTROL Port (D-Sub 9 Pin)
Use this port to connect a PC or control
system. This enables you to control the pro-
jector using serial communication protocol.
1. Check the product overview, supplied items and part names
1 2 7 4 8
8. REMOTE Terminal (Stereo Mini)
Use this terminal for wired remote control
of the projector.
NOTE:
• When a remote control cable is connected to the
REMOTE terminal, infrared remote control operations
cannot be performed.
• When [HDBaseT] is selected in the [REMOTE SENSOR]
and the projector is connected to a commercially-
available transmission device that supports HDBaseT,
remote control operations in infra-red cannot be carried
out if transmission of remote control signals has been
set up in the transmission device. However, remote
control using infrared rays can be carried out when the
power supply of the transmission device is switched off.
8
5
6