Table of Contents
Advertisement
Product Manual
WHBV-101W-LH-NB and WHBV-101W-RH-NB
5. Installation and Commissioning
5.1 Package Contents
Before you begin the installation, make sure that you have the following items:
1 x Product manual.
1 x WHBV-101W-RH-NBor WHBV-101W-LH-NB Wash basin with integral
push fit connectors.
1 x Waste pipe.
1 x End Support Angle.
2 x Side support angles.
1 x Bottom cover panel.
1 x 15mm to ½" BSP adaptor.
9 x M6x10 Button Head Torx Bolts
8 x M10x16 Stainless Steel security screws
NOTE:
An electronic control unit & solenoid water valves with cables are
supplied separately as an option. Various control options are available, contact
Galvin Engineering for more information.
5.2. Site Preparation
5.2.1 Mounting Guidelines
The washbasin must be attached to a vertical surface that can support the weight
of the washbasin. See Table 1 on page 16 for the weight. Refer to Figure 5 on
page 13 for a typical installation of the WHBV-101W-RH-NB.
The basin comes supplied with a 5 LPM flow regulator. Ensure the water supply
used has suitable dynamic pressure and flow rate to achieve the maximum
output. See Table 1 on page 16 for the specifications of the water supplies. The
tap outlet can be connected to a water supply that is cold or pre-mixed hot as
preferred.
You must drill holes in the wall for the support brackets, water supply pipe and
waste pipe as given in Figure 3 and 4. This basin is not provided with any wall
fixings and the user/customer must provide these.
NOTE:
A 1:1 scale template for drilling the holes is available on request
Revision 5
7
Advertisement
Table of Contents
