Preparing The Washbasin - Wallgate WHBV-101W-LH-NB Product Manual

Product Manual
WHBV-101W-LH-NB and WHBV-101W-RH-NB

5.3 Preparing the Washbasin

The washbasin must be prepared before attaching it to the desired walls. To prepare
the washbasin refer to figures 3 or 4 and 5 & follow the instructions below:
1. Remove the protective paper covers from the push fit connector on the water
inlet of the basin.
2. Once the desired height for the basin has been chosen, refer to figure 3 or 4
for the position and size of the required holes.
3. Before the basin is mounted onto the desired walls, the end support bracket
(Item 1, figure 5) must be secured to the wall first to aid the mounting (Section
5.4). The wall fixings required are not supplied and must be provided by the
installer.
4. Assemble the 15mm to ½" BSP adaptor (Item 8, figure 5) into the integral
push-fit connection on the basin inlet and attach a water supply pipe. The
water supply connection is provided on site by others. Site conditions and the
type of connection will determine whether it's best to connect to the basin
before or after mounting on the wall.
5. Push the waste pipe (Item 5, figure 5) into the brass socket on the rear of the
basin. The brass socket has a groove which is fitted with an O ring seal. The
socket is labelled C in Figures 3 and 4.
NOTE: Lubricate the end of the waste pipe with soap or water to ease the fit
and avoid damage to the O ring seal.
NOTE: Water management controls are supplied by others and should be
connected to the water supply pipe on the basin.
If installed within the basin cavity, for ease of installation, it is recommended to
fit controls before mounting to the wall.
Note: Depending on the installation, a TMV should be provided to manage the
water temperature.
Revision 5
12