Table of Contents
Advertisement
Product Manual PSH-23
5. Installation and Commissioning
5.1.
Package Contents
Before you begin the installation, make sure that you have the following items:
✓ 1x Product manual
✓ 1x Hand basin fitted with water solenoid valve, water inlet isolation valve
and waste outlet grille and pipe tail size 1 ½" (40mm)
✓ 2x Wall brackets
✓ 4x M10 Fixing studs with 4 nuts and washers
✓ 1x Piezo touch button, aluminum extension tube and flange nut
NOTE:
An electronic control unit is required to operate with this basin and is
sold separately. Various control options are available, (Models: WDC100 and
WDC200), contact the Wallgate sales desk for more information.
5.2.
Site Preparation
1. The hand basin requires a wall aperture size of 375mm wide x 380mm high.
The height of the aperture from floor level should be positioned to suit the user
(typically 850mm gives a height of 1m to the basin opening lower edge).
2. The electronic control unit (Sold as a separate option, various models are
available, contact Wallgate sales office) must be permanently fixed to the wall,
and positioned above all water pipes and fittings as shown on the drawing
INS_PSH_23 (Figure 1). The control box has fixing points each side and can
be fitted using round head screw fasteners (No 8 x 1 inch).
3. The electronic control unit requires an electrical supply of 230v AC 50Hz
2Amp. The mains supply cable from the unit should be terminated into a
double pole fused spur connection unit that has a contact separation of at
least 3mm. This should be located alongside the unit and fitted with a 2-Amp
fuse. Care must be taken in positioning all electrical fittings in relation to the
position of the water supply pipes should a leak or burst pipe occur.
Warning! THIS APPLIANCE MUST BE EARTHED
Revision 7
7
Advertisement
Table of Contents
