Operation - Wells B406 Operation Manual

OPERATION

PREPARE THE CHAR-BROILER FOR USE
When using the broiler for the first
time, wipe the entire unit with a clean
damp cloth or sponge and mild deter-
gent. Rinse thoroughly clean water.
Dry with a soft clean cloth.
Remove the GRATE and raise the
ELEMENT ASSEMBLY.
Install the DRIP PAN and add 2"
(5cm) of tap water.
Release the ELEMENT SUPPORT
ROD by lifting the element assembly
slightly, then pulling the lower portion
of the support rod forward. Lower the ELEMENT ASSEMBLY gently.
MODEL B-406: Grate must be in-
stalled ABOVE elements.
Install the GRATE, front edge first.
The TANGS of the grate go DOWN
and point toward the FRONT. The
grooves on the underside of the grate
align with the elements. The rear
edge of the grate can be lowered
until it rests firmly on the elements.
MODELS B-446 and B-506: Grate(s) can be installed above or below
the elements.
ABOVE: Gently lower grate over
elements. The end with flush tabs
goes toward the front.
BELOW: Install one wing bolt in
each tab. The notch in the wing
rests on the lip of the drip pan. The
end with flush tabs must go toward
the front Adjust the wing bolts so
that , when the element assembly
is lowered, the top of the element
is 1/4" (6mm) below the top of the
grate fins.
Fig. 4 ELEMENT SUPPORT ROD
ELEMENT
HANDLE
FRONT
GRATE TANG
Fig. 5 B-40 GRATE INSTALLATION
Fig. 6 B-44 and B-50 GRATE INSTALLATION
7
CAUTION:
Hot Surface
Exposed surfaces
can be hot to the touch and
may cause burns.
IMPORTANT: DO NOT at-
tempt to raise the element
assembly without first remov-
ing the grate. Damage to
the hinges will result. Such
damage is NOT covered by
warranty.
IMPORTANT: Allow drip pan
to cool before removing from
the broiler.
DO NOT operate the broiler
without the drip pan installed.
DO NOT operate the broiler
without 2" (5cm) of water in
the drip pan.
IMPORTANT: DO NOT at-
tempt to lower the element
assembly without first releas-
ing the support rod. Damage
to the hinges will result. Such
damage is NOT covered by
warranty.